Sharkoon BANDIT Spécifications télécharger pdf (Page 5)

BANDIT

3. Remove the mainboard and screw the stand-offs into the respective drillings

 ofthemountingpanel(g.3).

(Stand-offs)

ﬁg. 3

4.PresstheI/Oshield(deliveredwiththemainboard)intotheI/Oshield

opening in the case’s back side.

5. Place the mainboard back onto the stand-offs and screw the mainboard to

 them(g.4).

 (Screwsformainboardmounting)

ﬁg. 4

Note:

For more information on how to install the intended devices, refer to their

respective documents.

5. Installation of a mainboard

1. Open the case by loosening the thumb screws on the case’s back side and

 removingtheleftsidepanel.Laydownthecasesidewiseonanevensurface.

2. The mainboard’s mounting panel inside the case provides various drillings to

 xthestand-offs(g.1).

ﬁg. 1

 Themainboardcontainsspecialscrewopenings(g.2).

ﬁg. 2

Place the mainboard to the mounting panel. A stand-off must be screwed

into every drilling of the mounting panel visible through the mainboard’s

screw openings.

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Sharkoon BANDIT Spécifications Page 5