Sharkoon BANDIT Spécifications télécharger pdf (Page 6)

BANDIT

6. Plug the connectors of the case’s front bezel to the respective connectors of

 themainboard(alsorefertoyourmainboard’smanualforfurtherinformation).

Note:

The eSATA cable connected to the front eSATA connection should not exceed

50 cm of length otherwise transmission errors may occur! With premium

quality eSATA cables this maximum length may be exceeded.

6. Installation of a PSU

1. Set up the case in front of you and put the PSU from the inside against the

 PSUbracketonthecase’sbackside(g.5).

ﬁg. 5

2.ScrewthePSUtothecasefromtheoutside(g.6).

 (ScrewsforPSUmounting)

ﬁg. 6

7. Installation of a HDD

1. Remove the case’s right side panel.

2.Removethefrontbezel’sxationscrewsonbothsides(g.7).

ﬁg. 7

3.Removethecase’sfrontpanelbygentlydraggingittowardsyou(g.8).

ﬁg. 8

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Sharkoon BANDIT Spécifications Page 6